Toyota Grand Highlander (AS10): Selecting wheel set

Your vehicle is equipped with a tire pressure warning system with a function to register two sets of ID codes. This allows for registration of a second wheel set, for example a winter set.

  • The wheel set can be changed only if a second wheel set has been registered to the system. If a second wheel set has not been registered, "Switching Incomplete See Owner's Manual" will be displayed and it will not be possible to change to the selected wheel set.

ID codes can be registered by yourself.

  • Only a change between both registered wheel set is possible, mixing between these wheel sets is not supported.
  • While registering ID codes, it may not be possible to change between wheel sets normally. Cancel registration before changing between wheel sets.

■ Changing ID codes between different wheel sets

1. Install the desired wheel set.

2. Select display using the of the multi-information display using the meter control switches and then press .

3. Select "Vehicle Settings" and then press .

4. Select "TPWS setting" and then press .

5. Select "Tire Set Switching" and then press .

6. Select "Register Valve / ID" and then press .

7. Select "Tire Set 1" or "Tire Set 2". Then press .

8. Select "Yes" and then press The tire pressure warning light will.

The tire pressure warning light will slowly blink 3 times, a message indicating that change is occurring will be displayed, and the wheel set change will begin.

Wheel set change will begin and the tire pressure warning light will blink for 1 minute and then illuminate.

Also, while the change is being performed, "---" will be displayed for the tire inflation pressure of each tire on the multi-information display.

After approximately 2 minutes, the wheel set change will complete, the tire pressure warning light will turn off, and a completion message will be displayed on the multi-information display.

If changing does not complete after approximately 4 minutes, a message indicating that the change could not be completed will be displayed.

Check which wheel set is installed and perform the change procedure again from the beginning.

9. If the specified tire inflation

9. If the specified tire inflation pressure of the wheel set installed differs from that of the previous set, it will be necessary to perform the tire inflation pressure setting procedure of the tire pressure warning system.

If the specified tire inflation pressure is the same, it will not be necessary to perform the tire inflation pressure setting procedure.

10. Register the position of each wheel.

■If "Tire Set Switching Incomplete Try Tire Set Registration Again See Owner's Manual" is displayed

The wheel set change could not be completed.

Check which wheel set is installed and perform the change procedure again from the beginning.

    Share this page:

    Similar pages:

    Registering the position of each wheel
    ■ When to register the position of each wheel It is necessary to register the position of each wheel after performing a tire rotation. Wheel position registration can be performed by oneself. Wheel position registration is performed by driving forward with moderate left and right turns. However, ...

    Using the interior lights
    Interior lights list Location of the interior lights Front personal lights Front interior lights Center console light Open tray lights (if equipped) Door courtesy lights Rear personal lights Outer foot lights (if equipped) Ambient lights (if equipped) Operating the interior lights ■ ...