Toyota Grand Highlander (AS10): Cleaning the Digital Rearview Mirror

■ Cleaning the mirror surface

If the mirror surface is dirty, the image on the display may be difficult to see. Clean the mirror surface gently using a soft dry cloth.

■The camera

The camera for the Digital

Rear-view Mirror is located as shown.

NOTICE

NOTICE

■To prevent the camera from malfunctioning

  • Observe the following precautions, otherwise the Digital Rear-view Mirror may not operate properly.
    • Do not strike or hit the camera or subject it to a strong impact, as the camera installation position and angle may be changed.
    • Do not remove, disassemble or modify the camera.
    • Do not allow an organic solvent, car wax, window cleaner or glass coating to adhere to the camera. If this happens, wipe it off as soon as possible.
    • When applying colored film (including transparent film) to the rear window glass, do not apply it to the area in front of the camera. If film is applied to the area in front of the camera, the image from the camera may not display properly.
  • Do not subject the camera to a strong impact as this could cause a malfunction.

    If this happens, have the vehicle inspected by your Toyota dealer as soon as possible.

If you notice any symptoms

If you notice any of the following symptoms, refer to the following table for the likely cause and the solution.

If the symptom is not resolved by the solution, have the vehicle inspected by your Toyota dealer.

Outside rear view mirrors

    Share this page:

    Similar pages:

    If the engine will not start
    If the engine will not start even though correct starting procedures are being followed, consider each of the following points: The engine will not start even though the starter motor operates normally. One of the following may be the cause of the problem: There may not be sufficient fuel in the ...

    Air conditioning filter
    The air conditioning filter must be changed regularly to maintain air conditioning efficiency. Removing the air conditioning filter 1. Turn the engine switch off. 2. Open the glove box. Slide off the damper. 3. Push in each side of the glove box to disconnect the claws. Then pull out the glove box ...