Toyota Grand Highlander (AS10): Turn signal lever

Operating instructions

  1. Right turn
  2. Lane change to the right (move the lever partway and release it)
    The right hand signals will flash 3 times.
  3. Lane change to the left (move the lever partway and release it)
    The left hand signals will flash 3 times.
  4. Left turn

■Turn signals can be operated when

The engine switch is in ON.

■If the indicator flashes faster than usual

Vehicles with Front turn signal lights/parking lights (bulb type):

Check that a light bulb has not burned out.

Otherwise, have the vehicle inspected by your Toyota dealer.

■If the turn signals stop flashing before a lane change has been performed

Operate the lever again.

    Share this page:

    Similar pages:

    Installing the spare tire
    1. Remove any dirt or foreign matter from the wheel contact surfaces and wheel nuts. If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to come off. 2. Install the spare tire and loosely tighten each wheel nut by hand by ap ...

    Trailer towing (vehicles without towing package)
    Toyota does not recommend towing a trailer with your vehicle. Toyota also does not recommend the installation of a tow hitch or the use of a tow hitch carrier for a wheelchair, scooter, bicycle, etc. Your vehicle is not designed for trailer towing or for the use of tow hitch mounted carriers. Trail ...