Toyota Grand Highlander (AS10): Rear window wiper and washer

NOTICE

■When the rear window is dry

Do not use the wiper, as it may damage the rear window.

Operating the wiper lever

Operating the operates the rear wiper as follows: switch operates the rear wiper as follows:

  1. (Canada) (U.S.A.) or Off(Canada) Off
  2. (Canada) (U.S.A.) or Intermittent operation (Canada) Intermittent operation
  3. (Canada) (U.S.A.) or Normal operation (Canada) Normal operation

  1. operation Washer/wiper dual operation

Pushing the lever operates the wiper and washer.

The wiper will automatically operate a couple of times after the washer squirts.

The washer will automatically operate and clean the camera for the Digital Rear-view Mirror*1 and rear camera*2.

*1:If equipped
*2:Refer to the "MULTIMEDIA OWNER'S MANUAL".

■The rear window wiper and washer can be operated when

The engine switch is in ON.

■Operating the rear window wiper and washer using the voice control system*

*: If equipped

The following operation can be performed using the voice control system.

  • Operating the rear window wiper only once
  • Operating the rear window washer (it can be performed only when the vehicle is stopped)

For details regarding the voice control system, refer to the "MULTIMEDIA OWNER'S MANUAL".

■If no washer fluid sprays

Check that the washer nozzle is not blocked if there is washer fluid in the washer fluid tank.

■Reverse-linked rear window wiper function

When the shift position is shifted to R when the front wipers are operating, the rear window wiper will operate once.

■Back door opening linked rear window wiper stop function

When the rear window wiper is operating, if the back door is opened while the vehicle is stopped, operation of the rear window wiper will be stopped to prevent anyone near the vehicle from being sprayed by water from the wiper. When the back door is closed, wiper operation will resume.

NOTICE

■When the washer fluid tank is empty

Do not operate the switch continually as the washer fluid pump may overheat.

■When a nozzle becomes blocked

In this case, contact your Toyota dealer.

Do not try to clear it with a pin or other object. The nozzle will be damaged.

■To prevent battery discharge

Do not leave the wiper on longer than necessary when the engine is off.

    Share this page:

    Similar pages:

    Sensors used by Toyota Safety Sense 3.0
    Various sensors are used to obtain the necessary information for system operation. ■ Sensors which detect the surrounding conditions Front radar sensor Front camera Front side radar sensors* Rear side radar sensors *: If equipped ■ Sensors which detect the driver condition Driver monit ...

    Selecting wheel set
    Your vehicle is equipped with a tire pressure warning system with a function to register two sets of ID codes. This allows for registration of a second wheel set, for example a winter set. The wheel set can be changed only if a second wheel set has been registered to the system. If a second wh ...