Toyota Grand Highlander (AS10): Adding engine oil

■ Checking the oil type and preparing the item needed

Make sure to check the oil type and prepare the items needed before adding oil.

  • Engine oil selection
  • Oil quantity (Low level mark Refill upper limit mark) 1.6 qt. (1.5 L, 1.3 Imp. qt.)
  • Item
    Clean funnel

■ Adding engine oil

If the oil level is below or near the low level mark, add engine oil of the same type as that already in the engine.

1. Remove the oil filler cap by

1. Remove the oil filler cap by turning it counterclockwise.

2. Add engine oil slowly, checking the dipstick.

Make sure that the oil level does not exceed the refill upper limit mark and is between the low level mark and refill upper limit mark.

  1. Low level mark
  2. Refill upper limit mark

The shape of the dipstick may differ depending on the type of vehicle or engine.

3. Install the oil filler cap by turning it clockwise.

■After changing the engine oil

After the engine oil has been replaced, the engine oil maintenance data should be reset. Perform the following procedures:

1. Park the vehicle in a safe place and then start the engine.

The oil maintenance cannot be reset while the vehicle is moving.

2. Select display using the meter control of the multi-information display using the meter control switches and then press .

3. Select "Vehicle Settings" and then press and hold .

4. Select "Oil Maintenance" and then press .

5. Select "Yes" and then press .

"Reset Complete" will be displayed on the multi-information display when the reset procedure has been completed.

WARNING

■Used engine oil

  • Used engine oil contains potentially harmful contaminants which may cause skin disorders such as inflammation and skin cancer, so care should be taken to avoid prolonged and repeated contact. To remove used engine oil from your skin, wash thoroughly with soap and water.
  • Dispose of used oil and filters only in a safe and acceptable manner. Do not dispose of used oil and filters in household trash, in sewers or onto the ground.

    Call your Toyota dealer, service station or auto parts store for information concerning recycling or disposal.

  • Do not leave used engine oil within the reach of children.

NOTICE

■When replacing the engine oil

  • Be careful not to spill engine oil on the vehicle components.
  • Avoid overfilling, or the engine could be damaged.
  • Check the oil level on the dipstick every time you refill the vehicle.
  • Be sure the engine oil filler cap is properly tightened.

■If oil is spilled on the engine cover

To prevent the engine cover from being damaged, remove any engine oil from the engine cover as soon as possible using a neutral detergent. Do not use an organic solvent such as brake cleaner.

    Share this page:

    Similar pages:

    Fastening and releasing the seat belt (except for the third center seat)
    To fasten the seat belt, push the plate into the buckle until a click sound is heard. To release the seat belt, press the release button A. ■When not using the rear seat belts Pass the outer seat belts through the seat belt hangers and secure the seat belt plates to prevent the shoulder be ...

    Refueling
    Opening the fuel tank cap Perform the following steps to open the fuel tank cap: Before refueling the vehicle Close all the doors and windows, and turn the engine switch off. Confirm the type of fuel. ■Fuel tank opening for unleaded gasoline To help prevent incorrect fueling, your vehicle ha ...