Toyota Grand Highlander (AS10): Headlight aim

Vertical movement adjusting bolts

  1. Adjustment bolt A
  2. Adjustment bolt B

Before checking the headlight aim

1. Make sure the vehicle has a full tank of gasoline and the area around the headlight is not deformed.

2. Park the vehicle on level ground.

3. Make sure the tire inflation pressure is at the specified level.

4. Have someone sit in the driver's seat.

5. Bounce the vehicle several times.

Adjusting the headlight aim

1. Using a Phillips-head screwdriver, turn bolt A in either direction.

Remember the turning direction and the number of turns.

2. Turn bolt B the same number

2. Turn bolt B the same number of turns and in the same direction as step 1.

If the headlight cannot be adjusted using this procedure, take the vehicle to your Toyota dealer to adjust the headlight aim.

Light bulbs

    Share this page:

    Similar pages:

    If the engine will not start
    If the engine will not start even though correct starting procedures are being followed, consider each of the following points: The engine will not start even though the starter motor operates normally. One of the following may be the cause of the problem: There may not be sufficient fuel in the ...

    Rear seats
    The seat position and seatback angle can be adjusted, and the seatback can be folded by operating a seatback angle adjustment lever. WARNING â– Seat adjustment To reduce the risk of sliding under the lap belt during a collision, do not recline the seat more than necessary. If the seat is too r ...