Toyota Grand Highlander (AS10): Emergency flashers

The emergency flashers are used to warn other drivers when the vehicle has to be stopped on the road due to a breakdown, etc.

Operating instructions

Press the switch.

All the turn signal lights will flash.

To turn them off, press the switch once again.

■Emergency flashers

■Emergency flashers

  • If the emergency flashers are used for a long time while the engine is not operating, the battery may discharge.
  • If any of the SRS airbags deploy (inflate) or in the event of a strong rear impact, the emergency flashers will turn on automatically.

    The emergency flashers will turn off automatically after operating for approximately 20 minutes. To manually turn the emergency flashers off, press the switch twice. (The emergency flashers may not turn on automatically depending on the force of the impact and conditions of the collision.)

    Share this page:

    Similar pages:

    Checking and replacing fuses
    If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. Checking and replacing fuses 1. Turn the engine switch off. 2. Open the fuse box cover. Engine compartment Push in the claw and remove the lid. Type A Type B ...

    Driving support system information display
    ■ Driving support system information Select to display the operational status of the following systems: PCS (Pre-Collision System) LTA (Lane Tracing Assist) LDA (Lane Departure Alert) LCA (Lane Change Assist) (if equipped) Dynamic radar cruise control Cruise control PDA (Proactive drivin ...