Toyota Grand Highlander (AS10): Content of multi-information display (Center)

■ Display contents

  • Driving support system information display
  • Navigation system-linked display
  • Settings
  • Warning message
  • Blank

■ Changing contents in a page

Select the desired content on the page's setting mode display.

1. Press the meter or control switch to select a meter control switch to select a page.

2. To enable page edit, press and hold the switch. meter control switch.

3. Press the meter or control switch to select a display meter control switch to select a display to be changed.

4. Press meter control or switch to select a content. meter control switch to select a content.

5. When the setting is complete, press ■ Driving support system.

■ Driving support system information display

Select to display the operational status of the following systems:

  • PCS (Pre-Collision System)
  • LTA (Lane Tracing Assist)
  • LDA (Lane Departure Alert)
  • LCA (Lane Change Assist) (if equipped)
  • Dynamic radar cruise control
  • Cruise control
  • PDA (Proactive Driving Assist)

■ Navigation system-linked display

Select to display the following navigation system-linked information:

  • Route guidance to destination
  • Street name

■ Settings

  • The meter display settings can be changed in .

Select to enable/disable the stopStop light indicator

Select to enable/disable the stop light indicator.

Select to change the language displayed.Language

Select to change the language displayed.

Select to change the units of measureUnits

Select to change the units of measure displayed.

Select to change the meter type.Meter Type

Select to change the meter type.

Select to change the meter style.Meter Style

Select to change the meter style.

1 dial: Select to change the displayDial Type

1 dial: Select to change the display of the speedometer or tachometer.

Select to enable/disable the EcoEco Driving Indicator Light

Select to enable/disable the Eco Driving Indicator Light.

Select to set the display of the fuelFuel Economy

Select to set the display of the fuel economy.

Select to change the display of theDrive Info Items

Select to change the display of the drive information.

Select to change the display of theTRIP A/B Items

Select to change the display of the drive information of TRIP A/B.

Select to enable/disable pop-upPop-up display

Select to enable/disable pop-up displays for each relevant system.

Select to reset the meter displayDefault settings

Select to reset the meter display settings to the default setting.

  • Vehicle functions and settings that can be changed in

■Street name display

Only street names which are included in the map data will be displayed.

■Suspension of the settings display

  • Some settings cannot be changed while driving. When changing settings, park the vehicle in a safe place.
  • If a warning message is displayed, operation of the settings display will be suspended.

WARNING

■Cautions during setting up the display

If the engine is running when changing the display settings, ensure that the vehicle is parked in a place with adequate ventilation.

In a closed area such as a garage, exhaust gases including harmful carbon monoxide (CO) may collect and enter the vehicle.

This may lead to death or a serious health hazard.

NOTICE

■During setting up the display

To prevent battery discharge, ensure that the engine is running while setting up the display features.

    Share this page:

    Similar pages:

    Headlight aim
    Vertical movement adjusting bolts Adjustment bolt A Adjustment bolt B Before checking the headlight aim 1. Make sure the vehicle has a full tank of gasoline and the area around the headlight is not deformed. 2. Park the vehicle on level ground. 3. Make sure the tire inflation pressure is at t ...

    If the vehicle becomes stuck
    Carry out the following procedures if the tires spin or the vehicle becomes stuck in mud, dirt or snow: Recovering procedure 1. Stop the engine. Set the parking brake and change the shift position to P. Do not press the shift release button after shifting the shift position to P. 2. Remove the mud ...