Toyota Grand Highlander (AS10): Settings display
■ Meter display settings that can be changed
- Stop light indicator Select to enable/disable the stop light indicator.
- Language
Select to change the language displayed. - Units
Select to change the units of measure displayed. - Meter Type
Select to change the meter type. - Dial Type
Select to change the display of the speedometer or tachometer. - Eco Driving Indicator Light Select to enable/disable the Eco Driving Indicator Light.
Fuel economy display
Select to change the average fuel consumption display to any of the following: trip average/total average/ tank average.Select to display/not display the audio system linked display.
Select to change the displayed content of the following:
- Display contents
Select to display/not display AWD operation status display.
- Drive information type
Select to change the drive information type display between trip information/ total information.
- Drive information items
Select to set the first and second items of the drive information display to any of the following: average vehicle speed/distance/elapsed time.
- Pop-up display
Select to enable/disable pop-up displays for each relevant system.
- Multi-information display off
Select to turn the multi-information display off.
To turn the multi-information display on again, press any of the following meter control switches
.
- Default setting
Select to reset the meter display settings to the default setting.
■Suspension of the settings display
- Some settings cannot be changed while driving. When changing settings, park the vehicle in a safe place.
- If a warning message is displayed, operation of the settings display will be suspended.
WARNING
■Cautions during setting up the display
If the engine is running when changing the display settings, ensure that the vehicle is parked in a place with adequate ventilation.
In a closed area such as a garage, exhaust gases including harmful carbon monoxide (CO) may collect and enter the vehicle.
This may lead to death or a serious health hazard.
NOTICE
■During setting up the display
To prevent battery discharge, ensure that the engine is running while setting up the display features.
Suggestion function
Displays suggestions to the driver in the following situations.
To select a response to a displayed suggestion, use the meter control switches.
■ Suggestion to enable the power back door
If the power back door system is disabled (setting on the multi-information display set to off) and the power back door switch on the instrument panel is operated, a suggestion message will be displayed asking if you wish to enable the power back door system.
To enable the power back door system, select "Yes".
After enabling the power back door system, press the power back door switch again to open or close the power back door.
Similar pages:
Fastening and releasing
the seat belt (except for
the third center seat)
To fasten the seat belt, push
the plate into the buckle until
a click sound is heard.
To release the seat belt,
press the release button A.
■When not using the rear seat
belts
Pass the outer seat belts through
the seat belt hangers and secure
the seat belt plates to prevent the
shoulder be ...
Driving the vehicle
The following procedures
should be observed to
ensure safe driving:
Driving procedure
■ Driving
1. With the brake pedal
depressed, change the shift
position to D.
Check that the shift position indicator
shows D.
2. If the parking brake is set,
release the parking brake.
If the parking brake is ...